Luminance detector outside tunnel

The Luminance detector outside tunnel can fully meet the requirements of the entire tunnel lighting control. The controller in the preset control mode automatically switches the lighting switch according to the preset parameters according to the measured value of the light source, providing the best value for tunnel lighting. Its design fully complies with CIE's requirements for tunnel lighting measurement and can meet the "Highway Tunnel Ventilation Lighting Design Code", and its overall design can fully meet the requirements of harsh working environments in the wild.

Installation method of illuminance detector outside the tunnel:

The tunnel light intensity monitor is installed on the walls of the designated area in the tunnel. In order to avoid damage to it by accidents or car wreckage, it must be installed at a height of about 4m and an appropriate position greater than 10m from the entrance of the tunnel. The illuminance detector outside the tunnel is installed at an appropriate position where the height outside the tunnel is about 4m away from the road surface and about 120-200m away from the entrance of the tunnel. High reliability and low maintenance. Latest microprocessor technology, fully digitally run, installation

Easy to debug the illuminance detector outside the tunnel.

Technical parameters:

Measuring range: 0～7500cd/m2; maximum measurement of 10000cd/m2

Measurement accuracy: 0.1cd/m2

Local data storage is greater than 72 hours

Working temperature: -50℃～+70℃

Working humidity: 0～100%RH

Average failure-free time: ≥50,000 hours

Protection level: IP68

Power supply: 180～265VAC50Hz

Digital interface: RS485 data bus